Routing Information Protocol (RIP) Configuration.

RouterA#show ip route

Gateway of last resort is not set

C 1.0.0.0/8 is directly connected, serial0/1

C 3.0.0.0/8 is directly connected, serial0/0

C 192.168.1.0/24 is directly connected, loopback0

Configure RIP on Router A

RouterA#configure terminal

RouterA#(config)#router rip

RouterA#(config-router)#network 3.0.0.0

RouterA#(config-router)#network 1.0.0.0

RouterA#(config-router)#network 192.168.1.0

RouterA#(config-router)#exit

RouterA#(config)#



Now verify these configuration on router A with command us under:

RouterA#show ip route

To check the routing protocol with this command.

RouterA#show ip protocols



RouterB#show ip route

Gateway of last resort is not set

C 1.0.0.0/8 is directly connected, serial0/1

C 2.0.0.0/8 is directly connected, serial0/0

C 192.168.1.0/24 is directly connected, loopback0



Configure RIP on Router B



RouterB#configure terminal

RouterB#(config)#router rip

RouterB#(config-router)#network 1.0.0.0

RouterB#(config-router)#network 2.0.0.0

RouterB#(config-router)#network 192.168.2.0

RouterB#(config-router)#exit

RouterB#(config)#



Now verify these configuration on router B with command us under:

RouterB#show ip route

RouterC#show ip route

Gateway of last resort is not set

C 2.0.0.0/8 is directly connected, serial1

C 3.0.0.0/8 is directly connected, serial0

C 192.168.3.0/24 is directly connected, loopback0



Configure RIP on Router C

RouterC#configure terminal

RouterC#(config)#router rip

RouterC#(config-router)#network 2.0.0.0

RouterC#(config-router)#network 3.0.0.0

RouterC#(config-router)#network 192.168.3.0

RouterC#(config-router)#exit

RouterC#(config)#



Now verify these configuration on router C with command us under:

RouterC#show ip route

Tagged in:

• router
• INFORMATION
• protocol